Yoko Littner Gun-- 95% complete

Need help with sewing techniques, or making a 10 ft sword? Seek help from other cosplayers here!
Post Reply
User avatar
Makira
Posts: 4
Joined: Mon Jan 10, 2011 2:39 pm

Yoko Littner Gun-- 95% complete

Post by Makira » Tue Apr 03, 2012 12:18 pm


rheck
Posts: 4
Joined: Sun Apr 01, 2012 10:14 pm

Re: Yoko Littner Gun-- 95% complete

Post by rheck » Tue Apr 03, 2012 1:54 pm

The butt of the Stock (yellow/black stripe section) is supposed to go against your shoulder. You can see in the ref picture you provided that the gap from the butt to the handle is much shorter than in your prop. If possible try trimming down the length of the top pipe so that you could hold the gun a little more realistically.

The bullet magazine/clip in the ref picture looks like it would hold maybe 5 bullets. I'm guessing based on the thickness of the shaft. On your actual prop it looks like about 10 bullets or double the length on the magazine. Possibly removing the bottom half would help with the sizing better.

I would suggest maybe a matte black paint instead of (guessing) black duct tape, or rather on top of it. Then apply matte silver sparingly for highlights. Though really this would be less of an impact as the shine from a distance isn't noticed.

Hope that helps ^^
As long as I'm able to create something I'm having fun.
My Cosplay, Prop, Photography Blog
My Cosplays :)

User avatar
Makira
Posts: 4
Joined: Mon Jan 10, 2011 2:39 pm

Re: Yoko Littner Gun-- 95% complete

Post by Makira » Wed Apr 04, 2012 1:09 am

Thank you very, very much for the helpful suggestions! <3

Post Reply